Our 30th anniversary offer on the Troika EVO runs until 31 January 2027.Get a quote

Get a quote

Flexo QC

Flexo plate measurement: catch plate faults before make-ready.

One scan gives you dot size, dot percentage, screen count, relief depth and angle. Spot plate defects in the plate room, not halfway through a print run.

The 3D view in Flexo QC of a real flexo plate scan, 3D Scan #1 at 165 lpi and 57 degrees, the dots coloured by height Flexo QC's Dot Information for that scan: 12.7% dot, screen 165 lpi, angle 57 degrees, height 62 µm, diameter 64 µm, spacing 154 µm

What one scan tells you.

Flexo QC with the same plate scan open from above: 3D Scan #1, 165 lpi at 57 degrees, the dot tops picked out on the plate

Dot size, relief and screen count

Flexo QC scans the plate in 3D and calculates dot area, screen ruling and relief height automatically, with no manual thresholding.

Flexo QC measuring a dot at set depths below its top, on two profiles through the same plate

Measure dots below the surface

Pick a plane a few microns below the dot peak to measure where the plate actually meets the substrate, complete with simulated dot gain under impression.

Flexo QC's Dot Definition tab: six dots on the plate filled from the 3D data, 13.0 percent dot at 164 lpi

Measure every dot in the patch

Top-down mapping measures every single dot in the patch at once, catching bridged highlights, cupped dots or uneven exposure in one view.

Screens from Flexo QC and real scans.

Dots on a reflective flexo plate picked out by Flexo QC

Clear and reflective plates in seconds.

For standard translucent and reflective photopolymer plates, a rapid 2D snapshot gives you screen count and dot percentage in seconds.

Click two neighbouring dots and let the software calculate pitch, dot width and screen angle straight on the image.

Read: What separates good flexo from great
Depth map of a black elastomer plate, dots found below the surface

Black plates, measured in 3D.

Black elastomer and direct-engraved letterpress plates absorb light, hiding their dot edges from standard 2D plate readers.

Flexo QC uses true 3D topography to slice beneath the surface and measure dot shape, relief and diameter, making opaque black plates just as predictable as clear photopolymer.

Flexo QC with a cross-section through one dot on a real flexo plate scan, and the dot's profile from floor to top

Know how every dot will print.

A standard top-down camera only sees the tip of the dot. It misses weak shoulders that slur or collapse under press impression.

By slicing across the dot profile in 3D, Flexo QC measures shoulder angle, floor cleanliness and fine surface texturing down to the smallest highlight dot.

Scan in seconds.

Drop the EVO onto the plate and capture a reading in seconds. With focus and illumination locked in automatically, plate mounters and press operators get the exact same result every time.

Auto-focus locks on
Press 3D Scan to capture
See detailed results fast

Check every flexo plate before it goes to press.

Book a live demo and we'll take you through Flexo QC on a real plate scan, from dot size and relief to the slice below the dot tops. Flexo QC comes with the Troika EVO™, licensed for life.